HOME > FIRMWARE UPGRADE > FIRMWARE UPGRADE INSTRUCTIONS (SHOCKWAFE PRO 2016)

FIRMWARE UPGRADE INSTRUCTIONS
FOR SHOCKWAFE PRO 7.1 (2016) ONLY

​A. Preparing the USB Drive

1. Load a USB drive onto your computer, reformat the USB drive to "FAT32"

2. Open up file manager > Right click and select USB drive > Select format > FAT32

Click HERE for illustrated instructions

B. Downloading the Firmware

1. Download the firmware from the HERE

2. Extract the zip and upload the file named dvdrom.bin onto the USB drive. 

Click HERE for illustrated instructions

C. Disconnecting all HDMI cables from the Shockwafe Soundbar 

D. Upgrading the Shockwafe Pro Soundbar: (use the buttons on the soundbar)

1. Insert the USB drive at the back of the soundbar

2. Power ON the soundbar

3. Switch to AUX mode by pressing SOURCE. The 7th LED will light up. 

4. Press VOL "-" twice and VOL "+" twice. The 8th LED will blink continuously.

5. Press VOL "+" once. All LEDs will light up.

6. Firmware upgrade is in progress.DO NOT INTERUPT THE UPDATE. 

7. A "POP" sound will be heard and all LED will fade. Firmware upgrade is successful. 

8. Power OFF the soundbar

9. Remove the flashdrive

10. Perform a hard reset on the sound bar by unplugging the power from the mains

11. Wait 2 minutes and plug the power back into the mains. 

12. Check if the satellite speakers have audio, if not, using the remote: 

      Menu > Ch Up > SURR > Next > set to SURR ON

Customer Care:

support@nakamichi-usa.com

(415) 805 6913

(Weekdays 10am - 7pm PST; Weekends 10am - 5pm PST)

© 2019 NAKAMICHI LLC. ALL RIGHTS RESERVED.